175
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 4: MONITOR
Parameter description:
Interface: The interface type through which the remote host can access the switch.
Received Packets: Number of received packets from the interface when access management mode is enabled.
Allowed Packets: Number of allowed packets from the interface when access management mode is enabled
Discarded Packets: Number of discarded packets from the interface when access management mode is enabled.
Buttons:
- Auto-refresh: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
- Clear: Clears the counters for the selected port.
- Refresh: Click to refresh the page.
4.5.2 NETWORK
4.5.2.1 PORT SECURITY
This section shows the Port Security status. Port Security is a module with no direct configuration. Configuration comes indirectly
from other modules —the user modules. When a user module has enabled port security on a port, the port is set up for software-
based learning. In this mode, frames from unknown MAC addresses are passed on to the port security module, which in turn asks
all user modules whether to allow this new MAC address to forward or block it. For a MAC address to be set in the forwarding state,
all enabled user modules must unanimously agree on allowing the MAC address to forward. If only one chooses to block it, it will be
blocked until that user module decides otherwise. The status page is divided into two sections—one with a legend of user modules
and one with the actual port status.
WEB INTERFACE
To configure a Port Security Switch Status Configuration in the web interface:
1.Click Security, Network, Port Security, then Switch.
2. Check Auto-refresh.
3. Click Refresh to refresh the port detailed statistics.
To Next Page
Loading...
