198
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 4: MONITOR
4.6.2 PORT STATUS
This section describes how to set LACP function on the switch, then it provides a Port Status overview for all LACP instances.
WEB INTERFACE
To display the LACP Port status in the web interface:
1. Click Monitor, LACP, Port Status.
2. To auto-refresh the information, click Auto-refresh.
3. Click “Refresh“ to refresh the LACP Port Status.
FIGURE 4-34. LACP STATUS SCREEN
Parameter description:
Port: The switch port number.
LACP: Yes means that LACP is enabled and the port link is up. No means that LACP is not enabled or that the port link is down.
Backup means that the port could not join the aggregation group but will join if other port leaves. Meanwhile its LACP status is
disabled.
Key: The key assigned to this port. Only ports with the same key can aggregate together.
Aggr ID: The Aggregation ID assigned to this aggregation group. IDs 1 and 2 are GLAGs while IDs 3-14 are LLAGs.
Partner System ID: The partner’s System ID (MAC address).
Partner Port: The partner’s port number connected to this port.
Partner Prio: The partner’s port priority.
Buttons:
- Auto-refresh: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
- Refresh: Click to refresh the page.
To Next Page
Loading...
