213
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 4: MONITOR
Parameter description:
Navigating the MLD Group Table
Each page shows up to 99 entries from the MLD Group table, default is 20, selected through the “entries per page” input field. When
first visited, the web page will show the first 20 entries from the beginning of the MLD Group Table.
The “Start from VLAN”, and “group” input fields allow the user to select the starting point in the MLD Group Table. Clicking the button
will update the displayed table starting from that or the closest next MLD Group Table match. In addition, the two input fields will —
upon a button click—assume the value of the first displayed entry, allowing for continuous refresh with the same start address.
The switch will use the last entry of the currently displayed table as a basis for the next lookup. When the end is reached the text “No
more entries” is shown in the displayed table. Use the button to start over.
MLD Snooping Information Table Columns
VLAN ID: VLAN ID of the group.
Groups: Group address of the group displayed.
Port Members: Ports under this group.
Buttons
- Auto-refresh: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
- Refresh: Click to refresh the page.
|<<: Updates the system log entries to the first available entry ID
>> : Updates the system log entry to the next available entry ID
4.10.2.3 IPV6 SFM INFORMATION
Entries in the MLD SFM Information Table are shown on this page. The MLD SFM (Source-Filtered Multicast) Information Table also
contains the SSM (Source-Specific Multicast) information. This table is sorted first by VLAN ID, then by group, and then by Port.
Different source addresses belong to the same group are treated as single entry.
WEB INTERFACE
To display the MLDv2 IPv6 SSM Information in the web interface:
1. Click Monitor, MLD Snooping, IPv6 SFM Information.
2. To auto-refresh the information, click Auto-refresh.
3. Click “ Refresh“ to refresh a entry of the MLDv2 IPv6 SSM Information.
4. Click “<< or >> “ to move to the previous or next entry.
FIGURE 4-48. IPV6 SFM INFORMATION SCREEN
To Next Page
Loading...
