241
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
Date: The date where the firmware was produced.
Buttons:
- Activate Alternate Image: Click to use the “Activate Alternate Image.” This button may be disabled depending on the system state.
- Cancel: Cancel activating the backup image. This navigates away from this page.
6.4 CONFIGURATION
The switch stores its configuration in a number of text files in CLI format. The files are either virtual (RAM-based) or stored in flash
on the switch.
There are three system files:
running-config: A virtual file that represents the currently active configuration on the switch. This file is volatile.
startup-config: The startup configuration for the switch, read at boot time.
default-config: A read-only file with vendor-specific configuration. This file is read when the system is restored to default settings.
You can also store up to two other files and apply them to running-config, thereby switching configuration.
6.4.1 SAVE STARTUP-CONFIG
This copies running-config to startup-config, so that the currently active configuration will be used at the next reboot.
WEB INTERFACE
To save running configuration in the web interface:
1. Click Browser to select Maintenance/Configuration in you device.
2. Click Apply Startup-Config Select.
FIGURE 6-5. SAVE STARTUP CONFIGURATION SCREEN
Parameter description:
Buttons:
- Save Configuration: Click to save configuration. The running configuration will be written to flash memory for system boot up to
load this startup configuration file.
CHAPTER 6: MAINTENANCE
To Next Page
Loading...
