242
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
6.4.2 UPLOAD
The configuration upload function will back up and save the switch’s configuration into the running web browser PC.
You can upload any of the files on the switch to the web browser. Select the file and click Upload running-config. This may take a little
while to complete, as the file must be prepared for upload.
WEB INTERFACE
To upload configuration in the web interface:
1. Click Browser to select Maintenance/Configuration in you device.
2. Click upload Select.
FIGURE 6-6. CONFIGURATION UPLOAD SCREEN
There are three system files:
1. running-config: A virtual file that represents the currently active configuration on the switch. This file is volatile.
2. startup-config: The startup configuration for the switch, read at boot time.
3. default-config: A read-only file with vendor-specific configuration. This file is read when the system is restored to default settings.
Parameter description:
Buttons:
- Upload Configuration: Click the “Upload” button, then the running web management PC will start to upload the configuration
from the managed switch configuration into the location PC. You can configure the web browser’s upload file path to keep the
configuration file.
CHAPTER 6: MAINTENANCE
To Next Page
Loading...
