32
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 3: SYSTEM CONFIGURATION
Parameter description:
User Name: The name identifying the user. This is also a link to Add/Edit User.
Password: Type the password. The allowed string length is 0 to 255, and the allowed content is the ASCII characters from 32 to 126.
Password (again): Type the password again. You must type the same password again in the field.
Privilege Level: The privilege level of the user. The allowed range is 1 to 15. If the privilege level value is 15, the user can access all
groups for full control of the device. Other values need to refer to each group privilege level. A user’s privilege level should be same
or greater than the group privilege level to have the access of that group. By default settings, most groups with privilege level 5 have
read-only access, and groups with privilege level 10 have read-write access. System maintenance users (software upload, factory
defaults and etc.) need user privilege level 15. Use privilege level 15 for an administrator account, privilege level 10 for a standard user
account, and privilege level 5 for a guest account.
Buttons:
- Apply – Click to save changes.
- Reset - Click to undo any changes made locally and revert to previously saved values.
- Cancel - Click to undo any changes made locally and return to the Users.
- Delete User - Delete the current user. This button is not available for new configurations (Add new user).
3.5.1.2 PRIVILEGE LEVEL
This page provides an overview of the privilege levels. The switch enables the user to set Account, Aggregation, Diagnostics, EEE,
GARP, GVRP, IP, IPMC Snooping, LACP, LLDP, LLDP, MED, MAC Table, MRP, MVR, MVRP, Maintenance, Mirroring, Ports, Private
VLANs, QoS, SMTP, SNMP, Security, Spanning Tree, System Trap Event, VCL, VLANs, Voice VLAN Privilege Levels from 1 to 15 .
WEB INTERFACE
To configure Privilege Level in the web interface:
1. Click System, Account, Privilege Level.
2. Specify the Privilege parameter.
3. Click Apply.
FIGURE 3-16. PRIVILEGE LEVEL CONFIGURATION SCREEN
To Next Page
Loading...
