51
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 3: SYSTEM CONFIGURATION
Parameter description:
These parameters are displayed on the RMON History Configuration page:
Delete: Check to delete the entry. It will be deleted during the next save.
ID: Indicates the index of the entry. The range is from 1 to 65535.
Desc: Indicates this event; the string length is from 0 to 127; default is a null string.
Type: Indicates the notification of the event; the possible types are:
- none: No SNMP log is created, no SNMP trap is sent.
- log: Create SNMP log entry when the event is triggered.
- snmptrap: Send SNMP trap when the event is triggered.
- logandtrap: Create SNMP log entry and send SNMP trap when the event is triggered.
Community: Specify the community when a trap is sent; the string length is from 0 to 127; default is “public.”
Event Last Time: Indicates the value of sysUpTime at the time this event entry last generated an event.
3.5.2 NETWORK
3.5.2.1 LIMIT CONTROL
This section shows you to to configure the Port Security settings of the Switch. You can use the Port Security feature to restrict input
to an interface by limiting and identifying MAC addresses.
WEB INTERFACE
To configure Limit Control in the web interface:
1. Select “Enabled” in the System Configuration Mode.
2. Check Aging Enabled.
3. Set Aging Period (Default is 3600 seconds).
To configure Limit Control Port in the web interface:
1. Select “Enabled” in the Port Configuration Mode.
2. Specify the maximum number of MAC addresses in the Port Configuration Limit.
3. Set Action (Trap, Shutdown, Trap & Shutdown)
4. Click Apply.
To Next Page
Loading...
