54
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 3: SYSTEM CONFIGURATION
- Limit Reached: Indicates that the limit is reached on this port. This state can only be shown if Action is set to None or Trap.
- Shutdown: Indicates that the port is shut down by the Limit Control module. This state can only be shown if Action is set to
Shutdown or Trap & Shutdown.
Re-open Button: If a port is shut down by this module, you may reopen it by clicking this button, which will only be enabled if this is the
case. For other methods, refer to Shutdown in the Action section.
NOTE: Clicking the reopen button causes the page to be refreshed, so non-committed changes will be lost.
Upper right icon (Refresh): You can click on this icon to refresh the Port Security information manually.
Buttons:
- Apply – Click to save changes.
- Reset- Click to undo any changes made locally and revert to previously saved values.
3.5.2.2 NAS
The section describes how to configure the NAS parameters of the switch. The NAS server can be employed to connect users to a
variety of resources, including Internet access, conference calls, printing documents on shared printers, or by simply logging on to
the Internet.
WEB INTERFACE
To configure a Network Access Server in the web interface:
1. Select “Enabled” in the Network Access Server Configuration Mode.
2. Check Reauthentication Enabled.
3. Set Reauthentication Period (Default is 3600 seconds).
4. Set EAPOL Timeout (Default is 30 seconds).
5. Set Aging Period (Default is 300 seconds).
6. Set Hold Time (Default is 10 seconds).
7. Check RADIUS-Assigned QoS Enabled.
8. Check RADIUS-Assigned VLAN Enabled.
9. Check Guest VLAN Enabled.
10. Specify Guest VLAN ID.
11. Specify Max. Reauth. Count.
12. Check Allow Guest VLAN if EAPOL Seen.
13. Click Apply.
To Next Page
Loading...
