Black Box LGB5510A - Publication Date

Publication date: , 2015
Revision A1
79
Command Summary
COMMAND
DESCRIPTION
P
M
show access management
Use the show access management user
EXEC command without keywords to
display the access management
configuration, or use the statistics
keyword to display statistics, or use the
<AccessId> keyword to display the
specific access management entry.
15
EXEC
clear access management statistics
Use the clear access management
statistics privileged EXEC command to
clear the statistics maintained by access
management.
15
EXEC
access management
Use the access management global
configuration command to enable the
access management. Use the no form
of this command to disable the access
management.
15
GLOBAL_CONFIG
access management <1-16> <1-4094>
<ipv4_addr> [ to <ipv4_addr> ] { [ web ] [ snmp ]
[ telnet ] | all }
Use the access management
<AccessId> global configuration
command to set the access
management entry for IPv4 address.
15
GLOBAL_CONFIG
access management <1-16> <1-4094>
<ipv6_addr> [ to <ipv6_addr> ] { [ web ] [ snmp ]
[ telnet ] | all }
Use the access management
<AccessId> global configuration
command to set the access
management entry for IPv6 address.
15
GLOBAL_CONFIG
no access management <1~16>
Use the no access management
<AccessIdList> global configuration
command to delete the specific access
management entry.
15
GLOBAL_CONFIG
access-list action { permit | deny }
Use the access-list action interface
configuration command to configure
access-list action. The access-list
interface configuration will affect the
received frames if it doesn't match any
ACE.
15
INTERFACE_PORT_LIST
access-list rate-limiter <1-16>
Use the access-list rate-limiter interface
configuration command to configure the
15
INTERFACE_PORT_LIST