WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
Go to www.blackmaxtools.com and register your new tool on-line. For any questions
about operating or maintaining your product, call the BLACK MAX Help Line! Your
product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual. For additional
registration instruction, refer to operator’s manual.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole.
Later uses: Check engine lubricant level and add lubricant if needed.
Carefully pour fuel into the tank. Avoid spillage.
Immediately replace fuel cap and hand tighten.
Wipe up any fuel spillage.
PRIME press the PRIMER BULB 10 times
slowly.
SET CHOKE lever to “FULL CHOKE”
position. Squeeze throttle trigger fully through
step 6.
Press the PRIMER BULB 10 times
slowly. Set choke lever to RUN. Pull
starter grip and rope until the engine
runs.
DEPRESS the “STOP” switch to the STOP position.
Warm Engine:
After 10 seconds, SET CHOKE lever to the
RUN position.
Cold Engine:
To Stop:
With throttle fully engaged, PULL starter grip
and rope sharply until engine runs. (Max 4 times)
• If 60°F or lower, continue to pull starter grip and
rope until engine runs.
• If 60°F or above, set CHOKE lever to “HALF
CHOKE” and pull starter grip and rope until
engine runs.
ENGINE STARTING PROCEDURE
1
2
3
4
4
5
5
2
4
1
6
3
5
6
LUBRICANT
1 GALLON
GAS
10x
HALF
CHOKE
10x
FULL
CHOKE
RUN
HALF
CHOKE
NOTICE
Do not use E15 or E85 fuel in
this product. It is a violation of
federal law and will damage
the unit and void your warranty. Only use unleaded
gasoline containing up to 10% ethanol.
1-800-726-5760
¿NECESITA AYUDA?
LLAME AL
www.blackmaxtools.com
995000951
9-10-19 (REV:02)
To Next Page
Need help?
General
