4
ENGLISH
(Original instructions)
Additional safety instructions for food
processors
Warning! Do not place near a hot Gas or electric oven.
• Do not Immerse Food Processor, Cord or Plug in any
liquid.
• Allow all moving parts of the appliance to come to a stop
before approaching.
• Always use on a clean work surface and clean the
surface thoroughly after use.
• Allow the appliance to cool before storing.
• Keep hands, long hair and loose clothing away from the
beaters.
• Always take care when handling the sharp cutting
blades when emptying the bowl and during cleaning.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
• This appliance includes a safety switch which prevents
operation unless the accessories are securely installed.
• This appliance incorporates a protective device against
high temperatures. If the temperature becomes too high,
the unit will turn off automatically and will resume
operation when the motor has cooled sufficiently (after
about 15 minutes).
• Do not operate the appliance for more than a minute at
a stretch.
• If operation is not finished within 1 minute, turn off the
machine and let it cool for 10 minutes before the next
round of operation. If more than 5 rounds of operation
are required, cool the machine for 90 minutes to room
temperature before the next 5 rounds. This can lengthen
lifespan of the machine.
Using an extension cable
• Always use an approved extension cable suitable for the
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear
and ageing. Replace the extension cable if damaged or
defective. When using a cable reel, always unwind the
cable completely.
Features
1. Motor base
2. Driver
3. Processing bowl
4. Blade adapter
5. Bowl cover
6. Pusher
7. Blade holder
8. Coarse slicing blade
9. Shredding blade
10. Fine slicing blade
11. Chopper
12. Kneading blade
13. Emulsifying disc
14. Citrus juicing plate
15. Citrus juicing head
16. Blender measuring cup
17. Blender jar cover
18. Blender jar
19. Blender blade
20. Transmission head
21. Grinder base
22. Grinding blade
23. Grinding cup
Assembly
Warning! Before performing any assembly or
maintenance, switch off and remove from power
supply.
Use
Warning! Let the appliance work at its own pace. Do not
overload.
• Clean the processing bowl, bowl cover, pusher, blade
holder, cutting blades, chopper, kneading blade,
emulsifying disc, citrus juicing head and plate and
blender assembly before use.
• Place the appliance on a flat, steady surface.
• Ensure that the power cord is unplugged from the power
outlet and the speed selector is set to the "0" position.
Chopper assembly
• Position the driver (2) on the motor base (1).
• Position the processing bowl (3) into the driver (2) and
turn clockwise to seat firmly on the motor base (1).
• Place the blade adaptor (4) onto the driver (2).
• Place the chopper (11) onto the blade adaptor (4).
To Next Page
Loading...
