5
(Original instructions)
u Insert the shank of the blade fully into the blade
clamp (11).
u Push the blade clamp lever (12) down to lock
the blade clamping mechanism.
Note: The blade can be installed with the teeth up
to assist in ush cutting
Removing the saw blade (g. A)
Warning! Burn hazard: Do not touch the blade
immediately after use. Contact with the blade may
result in personal injury.
u Pull the blade clamp lever (12) up to release
the blade clamping mechanism.
u Remove blade.
Use
Switching on and off
Note: Ensure the forward reverse slider (2) is not
in the locked position.
u To switch the tool on, press the variable speed
switch (1). The tool speed depends on how far
you press the switch.
u To switch the tool off, release the variable
speed switch (1).
Sawing
u Always hold the tool with both hands.
u Let the blade run freely for a few seconds
before starting the cut.
u Apply only a gentle pressure to the tool while
performing the cut.
u If possible, work with the shoe (13) pressed
against the workpiece. This will improve tool
control and reduce tool vibration, as well as
prevent the blade from being damaged.
Hints for optimum use
Sawing wood
u Clamp the workpiece securely and remove all
nails and metal objects.
u Holding the tool with both hands, work with the
shoe (13) pressed against the workpiece.
Sawing metal
Be aware that sawing metal takes much more time
than sawing wood.
u Use a saw blade suitable for sawing metal.
Use a ne-tooth saw blade for ferrous metals
and a coarser saw blade for non-ferrous met-
als.
u When cutting thin sheet metal, clamp a piece
of scrap wood to the back surface of the
workpiece and cut through this sandwich.
To Next Page
Loading...
Need help?
General
