10
Attaching the stand 40/188
40/188 attaching the Stand
To complete the stand installation you will need a Phillips screw driver.
Place the TV set on a at and clean surface with the panel facing downwards to avoid damage.
1
5 x ST (4x25)
4
6 x M(4x14)
/M(4x12)
2
( g.1) Attach the stand neck to the rear of the TV set. ( g.2) Secure the neck to the TV using the 6 x M(4x14)
screws.
( g.3) Next attach the stand ring to the neck. ( g.4) Secure the stand base to the stand neck using the
5xST(4x16) screws provided.
11
/2
3
11
BLAU-215-155_215-155_40-188.indd 10BLAU-215-155_215-155_40-188.indd 10 11/16/2012 2:02:42 PM11/16/2012 2:02:42 PM
To Next Page
Loading...
