57
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
TECHNICAL DATAPRE-AMPLIFIER / SUBOUT
Pre-amplifier / subout
You can use the connections provided on your
car radio to connect an external pre-amplifier
and a subwoofer.
We recommend that you use matching prod-
ucts from the Blaupunkt or Velocity ranges.
Switch-on delay for external pre-
amplifiers
You can set a switch-on delay for connecting
a pre-amplifier via the Pre-amp Out connec-
tion. The maximum delay is four seconds.
➮ Press the MENU button, 8.
➮ Press the or button, 7, as often
as is necessary for “AMP DLAY” to ap-
pear in the display.
➮ Press the or buttons, 7, in order
to adjust the switch-on delay.
“DLAY OFF” means that there is no switch-
on delay, while “DELAY 1” to “DELAY 4” indi-
cate the delay time in seconds.
➮ Press the OK button, 5 or the MENU
button, 8, to leave the menu. The set-
tings are then saved.
Technical data
Amplifier
Output power: 4 x 25 Watt sine wave
according to
DIN 45 324 at 14. 4 V
4 x 45 Watt max. power
Tuner
Wavebands:
VHF (FM) : 87.5 – 108 MHz
MW : 531 – 1,602 kHz
LW : 153 – 279 kHz
FM frequency response:
30 - 15,000 Hz
CD
Frequency response:
20 - 20,000 Hz
Pre-amp Out
4 channels: 4 V
AUX input
Sensitivity: 1,2 V / 10 kΩ
Subject to technical change!
To Previous Page
Loading...
