Sleep: in radio mode, short press the snooze/dimmer/sleep button repeatedly to adjust the sleep
time between 10/20/30/40/50/60/70/80/90/off circularly, short press the button again to review the
sleep remaining time. The radio will off automatically when the sleep time is being.
Alarm operation
Before start alarm setting, please make sure you have set up correct clock time. You can set up two
separation alarm timers according to following.
1. Long press the alarm1 button 2 seconds to activate the alarm setting mode, then the hour digits
will flash on display, press the hour and minute button to adjust the hour setting, press the alarm 1
button again to confirm and skip to minute setting which is same operation as hour's setting. Using
and repeat the same operation to finish the rest setting for alarm source (buzz/Radio) and volume
(1~12), short press the alarm1 button again to confirm and quite the alarm setting mode.
2. The operation method is same for alarm 2 setting, but you need long press the alarm 2 for
starting.
3. In case of you set up the alarm successfully, the relevant alarm indicator will light up on display.
4. When alarm is activate and ring up, press power/function button to cancel the sound, and the
alarm will ring up again tomorrow when the time is on.
Note:
Please do not remove the power; otherwise, the alarm will be disappeared base on no battery
power inside.
SNOOZE: When alarm sounds, press SNOOZE to activate the snooze time for 9 minutes. The AL1 /
AL2 indicator keeps blinking.
Display brightness (Dim) adjustment: in clock mode, long press the dimmer button repeatedly to
select high or low brightness level.
Battery back-up
(For Temporary Time Storage Only)
Install 2 x LR06, AA or EU-3 battery (not included) according to polarity shown inside the battery
compartment. In the event of a power interruption, your set will not work normally from the mains
supply but there is now the advantage that your clock will continue to work. The clock display will
not light up, as the clock time will be held in the memory. This also enables you to move the set
from place to place without re-setting the clock every time. The battery back-up system is only
meant to be used from short temporary power interruption. For longer durations, the battery may
become exhausted or there may be some deviation in accuracy. When the battery is exhausted, it
should be removed from the set to prevent leakage. If you do not wish to take advantage of the
battery back-up system, your set will work normally without a battery.
However, if disconnected from the mains, the clock figures will flash when the mains are re-
connected and you must re-set the clock as described in the Electronic Clock Operation paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don't throw used
batteries in dustbin. Please contact your retailer in order to protect the environment.
Attention should be drawn to the environmental aspects of battery disposal.
Electrical products should not be disposal of with household waste. Please recycle where facilities
exist. Check with your Local Authority of retailer for recycling device. (Batteries pack or batteries
installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
6
CR50GR
To Next Page
Loading...
