RX+ 12
4. Open up the battery door on the rear side, install and put 4 pcs 1.5V AAA
into the compartment. Please pay attention to direct the voltage +/-
polarity according to the symbol inside. When you are using battery power
supply, the whole functionality operation is the same as with DC power.
When the battery has low power, the display will show low battery bar.
When the battery is exhausted, the display show “Change Battery”, and
then switches Power OFF after two seconds.
Important note:
Please pick up the battery out of the unit if you are not going to use it for
long time in order to avoid battery liquid leakage issue and damage the
unit.
SPECIFICATION
Radio frequency: DAB (BAND III 5A-13F), FM (87.5MHz-108MHz)
Radio preset: 10 stations for DAB and FM each (max.).
Display: 2x16 blue background with white text, negative display.
Power: DC IN 5V/500Ma, or 4 x 1.5V AAA battery (not included)
Speaker RMS Output: 1.2 Watt
Power consumption (on mode): 3 Watt
Power consumption (standby mode): < 1 Watt
TROUBLE SHOOTING
We cannot receive some stations, and the radio output is coming with
noise and sound intermittently.
- Please fully extent the FM telescopic antenna and adjust the antenna for
better reception.
- Please move the radio to another position (for example: next to a
window) for better reception.
- Please reset the radio and scan the stations again.
41
To Next Page
Loading...
