2
Please refer to the following sheet for more details about each component.
Note:
To perform a factory reset press the reset/WPS button for 15 seconds until the green Indicator light
turns off and the red Indicator light turns on and starts flashing. Now wait until the Green Indicator light
flashes slowly. Now the camera is reverted to default settings.
For advanced users who want to configure by WPS instead of the recommended WIFI or Ethernet configuration,
please refer to Web Interface manual. To download the Web Interface manual, please visit our website
http://security.blaupunkt-service.com
Please refer to the following sheet for more details about status of indicator light.
Green light slow flashing
Booting completed, await Wi-Fi config, enter smart
config status.
Green light quick flashing
Wi-Fi smart config in progress, including WPS (Wi-Fi
Protected Setup), management frame etc.
Wi-Fi connection succeeded, operate normally.
Red and green lights flash
alternately
Device upgrade
Red light slow flashing
Network connection failure or disconnection after
network connection success.
Red light quick flashing
Device malfunction, fail to boot up; alarm or SD card
malfunction
①
Reset/WPS button
②
Micro SD card slot and Indicator light
③
Lower cover
④
Locking screw
To Next Page
Loading...
