Blaupunkt VIO-DP20 - Page 5

Note:
To perform a factory reset press the reset/WPS button for 15 seconds until the green Indicator light
turns off and the red Indicator light turns on and starts flashing. Now wait until the Green Indicator light
flashes slowly. Now the camera is reverted to default settings.
For adv
anced users who want to configure by WPS instead of the recommended WIFI or Ethernet configuration,
please refer to Web Interface manual. To download the Web Interface manual, please visit our website
http://security.blaupunkt-service.com
Please r
efer to the following sheet for more details about status of indicator light.
Indicator light status
Device status
Red light normally on
Booting
Green light slow flashing
Booting completed, await Wi-Fi config, enter smart config
status;
Green light quick flashing
Wi-Fi smart config in progress, including WPS (Wi-Fi
Protected Setup), management frame and etc.
Green light normally on
Wi-Fi connection succeeded, operate normally.
Red and green lights flash
Device upgrade
Red light slow flashing
Network connection failure or disconnection after
network connection success.
Red light quick flashing
Device malfunction, fail to boot up; alarm or SD card
malfunction
English
NOTE:
This Quick Start Guide focus on the installation and 1
st
time configuration of the camera with the
Cam4Home APP. For more information, please visit our website http://security.blaupunkt-service.com
• APP Usag
e: The complete Cam4Home APP manual can be downloaded from our website.
Additionally, the Cam4Home APP contains a Help menu and FAQ.
• Web Interface: For advanced users, we provide the professional camera configuration via Web
interface. We recommend IT knowledge before using the web interface. The advanced manual
can be downloaded from our website
.
• Professional desktop software: For advanced users, we provide the professional desktop
software Smart-PSS to manage and configurate the cameras. The Smart-PSS Software and
Manual can be downloaded from our website.
3