Thank you for purchasing the Blaux HeatCore desktop ceramic heater.
This portable and easy to use heater can be placed in your home, office,
or anywhere you please. It's highly energy-efficient and simple to use,
just plug it in and enjoy the warmth.
Care and Maintainence
To clean, allow your HeatCore to cool completely. Then, wipe the exterior
with a soft, damp cloth. Then wipe with dry soft cloth or air dry.
Important Safety Instructions
Read all instructions before using this heater.
How To Use
1. Plug the power cord into an outlet
2. Power on using the main power switch at the back
3. Turn on the fan by pressing the power button on top
4. Press the Fan button to the left of the power button to cycle between
the different heat modes.
5. Press the Timer button to the right of the power button to set a timer
(1/2/3 hr) for the fan. The device will shut itself off when the time
expires.
WARNING: DO NOT LEAVE BLAUX HEATCORE UNATTENDED,
ESPECIALLY IN THE PRESENCE OF CHILDREN OR PETS.
Fan Only
High Heat (1200W)
Low Heat (700W)
Power Standby ON/OFF
Timer: 1,2,3 Hour Auto Off
Ceramic Heater
Hot Air Outlet
Tip Over Safety Switch
Filter Cover
ZPT Anti-Microbial Filter
Air Inlet
Main Power Switch ON/OFF
Cord Wrap
Power Cord
1
2 5
5
6
7
4
3
1
2
3
4
12
8
9
10
11
12
14
13
9
11
10
6
8
7
13
14
0201 03
Tip over safety switch: There's a tack switch on the base of the unit, if
there's a tip over the switch will turn off the power of the heater to
prevent fire. At this point, the user will need to make sure the heater is
sitting on an even and flat surface and turn on the heater again for
additional safety reasons.
Cooldown timer: There's a 30 seconds cooldown timer after the heater
has been switched off from HI/LOW fan mode, it's for preventing heat
trapping in the heater to increase safety and prevent overheating of
the element.
•
•
Caution:
If the heater malfunctions and the internal temperature reaches 250°F/
121°C, the safety fuse will turn off the entire heater.
NOTE:
To Next Page
Need help?
General