Blitz HydroLift Series - Page 144

HydroLift
Inspection log book HydroLift
126746 141
Annual safety check
Only by an export
Carry out the following test steps.
Tick where appropriate.
Gradual safety check
OK
Defect
Missing
Verify
Comment
Quick Reference Guide




Type plate




Warning signs




Function raise / lower




Condition of load liftings wheel fork




Function procedure of the cylinder




Condition of welds




General condition of the lifting system




Condition of aggregates




State of control




Condition of control panel




Check supporting parts of lifting system
(deformation, cracks)




Condition of cylinder




Checking the screw torques




Function of the safety devices




Condition of covers




Hydraulic system tight




Filling level of hydraulic tank




Condition of the hydraulic lines




Condition of the electric cables




Function test when vehicle is raised




Security check performed
Date: .....................................................
Company: ..............................................
Expert (name, address)
..................................................................
......................................................................................................................................
Signature operator Signature expert
Defects remedied on.................................. For a check, use a separate form!
......................................................................................................................................
Signature operator Signature expert
Type designation ……………………………….
Serial number:…………………………………….
Result
Further operation questionable, inspection required 
Further operation possible, get rid of defects 
Further operation without concern, lifting system without
defect 
Please keep completed
form in the inspection
log book (annex)!