Filling and Heating:
Ensure drain plug and filters are in position, close door and press the on/off button for 3 seconds.
The machine fills up and stops when full and heats up, switch on ½ hr before first use, when
temperature is fully satisfied the temperature satisfied light illuminates, unit is ready for use.
Wash:
Remove scraps from items before loading into the basket, open the door and insert basket, close
door
Press and release the cycle button relating to the length of wash required, the cycle button will
illuminate when a cycle is in action. The cycle light goes out when the cycle is complete. Open the
door when finished and leave tray to dry (2 mins) before handling
Drain:
Gravity drain version: Switch off the unit, Open door, remove overflow drain plug, LEAVE FILTER
IN POSITION. Fig 3
Pump drain version: Open door, remove overflow drain plug, LEAVE FILTER IN POSITION Fig 3,
press and hold the short cycle button for 3 seconds, the drain pump will start and the button will
flash, when empty switch off the unit.
Cleaning:
Daily: drain machine, only when fully drained, remove filter fig4 and clean thoroughly, check upper
and lower wash arms spin freely by hand. Replace cleaned filter immediately and insert overflow
drain plug. Clean and dry the machine with a soft cloth. Check detergent and Rinse-aid chemicals
are topped up.
Weekly: Check all wash jets and rinse jets for blockages, remove and clean as necessary. If wash
arms are stiff, remove wash arms and clean arms and spigot thoroughly.
To Next Page
Loading...