Blodgett Combi BC14G - Page 34

BC14G AND BC14E
5-1
TROUBLESHOOTING SEQUENCE
ALWAYS troubleshoot a Synergy oven in the folĆ
lowing sequence;
1. Cool Down
2. Hot Air
3. Steam
4. Combi
By following this sequence you bring in components
gradually. DO NOT proceed to the next mode of opĆ
eration until you have verified Cool Down works first.
If possible, contact the customer before visiting the
sight and have them check operation of the Synergy
oven in each mode of operation. Suggested quesĆ
tions are listed with each failure mode. Have a scheĆ
matic in hand when asking questions. By asking the
questions in the proper sequence you are slowly
troubleshooting the circuit.
COOL DOWN MODE
NO operation with the mode switch in the COOL
DOWN mode.
1. Is the oven plugged in?
2. Is the deliming switch on the left hand side of
the oven in the ON" position?
3. Push the fan speed control switch. Does the
convection motor come on?
HOT AIR MODE
NO operation with the mode switch in the HOT
AIR mode.
1. Does the green power on light on the top right
corner of the control panel come ON" or light
up?
2. Turn the timer up to 10 minutes and then
manually turn the timer down to the zero"
position. Does the timer alarm BUZZ" or
sound?
3. If you turn the thermostat knob up, does the
red thermostat light to the right of the thermoĆ
stat come ON" or light up?
(Gas Ovens Only)
4. Is the gas turned ON" in the rear of the oven
and turned ON" in the slide panel in the lower
left on the front of the oven?
5. Turn the mode switch to the OFF" position
and then turn it back on to the HOT AIR"
mode. Can you hear the oven sparking" or
tickĆtickĆtick"?