Blue Hawk FLUX-MIG 100 SGY-WELDER1 User Manual (English)

Questions and Answers:

T
tkiddAug 2, 2025
What to do if the wire feeds but shielding gas does not flow on Blue Hawk Welding System?
- J
  James HayesAug 2, 2025
  If your Blue Hawk Welding System's wire feeds but the shielding gas doesn't flow, several issues could be the cause: * The gas cylinder may be empty, so check the gas cylinder. * The nozzle might be plugged; try clearing it, and replace it if damaged. * The regulator or cylinder valve may be closed; ensure both valves are adjusted correctly. * A blocked gas line could be the problem; inspect the external hose and the hose within the torch cable. * A broken or improperly connected gas solenoid might be at fault; have a qualified technician check or replace it.
A
Austin FriedmanAug 11, 2025
Why Blue Hawk Welding System welder does not function when switched on?
- V
  Victoria CollinsAug 12, 2025
  If your Blue Hawk Welding System welder doesn't function when switched on, here are a few potential causes and solutions: 1. The thermal protection device may have tripped. Turn the welder off and allow it to cool for at least 20 minutes. Reduce the duration or frequency of welding to decrease wear. Refer to the duty cycle graph. 2. There may be a faulty or improperly connected switch body. Have a technician check and secure or replace the switch body. 3. An internal fuse might have blown. Have a qualified technician check or replace it.
W
William OdonnellAug 21, 2025
What to do if wire feeds but arc does not ignite on Blue Hawk Welding System?
- D
  Dean HernandezAug 21, 2025
  If the wire feeds but the arc does not ignite on your Blue Hawk Welding System, it could be due to a couple of reasons: * Check the ground connection: ensure the ground clamp properly contacts the workpiece and that the workpiece is clean near both the ground clamp and the welding location. * Inspect the contact tip: verify it's the correct size for the welding wire, not deformed, enlarged, or dirty. Replace it with the proper size and type if needed.