Blue Thumb Serenity - Connect Flexible PVC Pipe; Attach Liner to Waterfall

Hook-Up Flexible PVC Pipe
The Serenity Waterfalls are plumbed to accept 1.5”
Flexible PVC Pipe. We recommend using Flexible
PVC pipe as it is very exible and easy to work with.
Using PVC Primer & Cement, glue the ex pipe into
the PVC male adapter.
If you are using Vinyl or Kink-Free Tubing rst glue
the included Barbed tting into the PVC 90 adapter
using PVC Primer & Cement. Then attach the tubing
to the barbed end and secure with a hose clamp.
Attach Liner to Waterfall
Bring the liner up to the face of the waterfall box
and check the positioning of the liner against the
waterfall box. The liner should follow the contours
of the pond edge or stream and the face of the
waterfall box. It is a good idea to leave a little slack
in the liner where it transitions from the pond edge
or stream to the face of the waterfall box. This will
ensure that the weight of the rocks used in the
waterfalls will not pull down on the liner.
Using boulders and rockwork, begin building the
waterfall up the face of the box. Be sure to keep
the liner pinched into position against the waterfall
with the rockwork. The Serenity Waterfall has
several drip points that will not allow any water to
leak between the liner and the waterfall box when
installed properly.
Another option is to bring the liner up behind the
waterfall box so that the entire box is sitting inside
the liner.
STEP 4
STEP 5