Advanced Button Functions
> To hold an active call and switch to an incoming or held
call, press Vol + for about 1 second.
> To end an active call and answer a new incoming call,
press Vol - for about 1 second.
> You can conference two active calls together by holding
the MFB for 3 seconds (if your phone and network support
this).
> To transfer audio to the phone, click Vol + and Vol -
together during a call.
> To disconnect your phone from the T1, click Vol + and Vol-
together when you are not on a call. Hold down Vol + for
about 1 second to reconnect.
11
Advanced Button Functions
> During a call you can mute and unmute the T1 microphone
by holding Vol + and Vol - together until the T1 beeps twice
(about 1 second).
> Whenever you add contacts to your phone you must also
update your phonebook on the T1: with the T1 connected
to your phone but not on a call, hold down the MFB for 3
seconds to initiate a phonebook update.
> To turn the fl ashing indicator light on or off, disconnect
the T1 from your phone and hold down Vol + and Vol - for
1 second.
> Click the MFB to: end a call, cancel pair mode, cancel voice
recognition, or cancel a phonebook transfer/update.
12
To Next Page
Loading...
