Blueant TalkX - Page 12

Troubleshooting
If you are having problems with your TalkX in Windows, please check under Audio in the Bluetooth and other
devices tab.
You should see the “BlueAnt TalkX" listed and underneath the BlueAnt TalkX it should say “Connected voice, music”
If it only says "Connected music” and does not mention “voice”, then the microphone will not work.
If this is the case please click select the “BlueAnt TalkX" and then click “Remove device""
When prompted if you “Are sure you want to remove this device?", click “Yes"
Please save anything you were doing and reboot your computer.
While this is happening, please perform a factory reset on your TalkX.
You can do this when not connected to any devices by pressing and holding Volume + and Volume - for 10 seconds.
The TalkX will announce that “Factory Reset is complete” and then power down.
Once your computer has rebooted please go back to the “Bluetooth and other devices” menu and click
“Add bluetooth or other device” again. Click on “Bluetooth”.