BLUM LEGRABOX

Height adjustment
± 2 (3/32")
Side adjustment
± 1.5 (1/16")
Tilt adjustment
M height
+
1.5 /-0.5 (1/16"/1/32")
C/F height ± 1.5 (1/16")
1 2
3
1
2
2
T20
1
2
3
T20
1
2
3
3
2
T20
1
2
3
1 2
3
1
2
2
Drawer front removal
Retting drawerDrawer removal
Cover cap removal
Height, side and tilt adjustments
Pull drawer forward to reveal locking devices. Squeeze triggers
on locking device and lift drawer box o runners.
DRAWER INSTALLATION AND ADJUSTMENT
Drawer installation and adjustment video: https://youtu.be/v92uq8QGx7g
Fully extend runners. Place drawer onto runners, ensure
runners are bedded fully in drawer base channel. Place hand in
middle of drawer front and close the drawer pushing back
rmly until a double click is heard.
Turn adjustment screw to release front xing bracket. Lift
drawer front away from drawer box.
Height adjustment - Turn the adjustment screw clockwise
to raise or lower the drawer front.
Side adjustment - Turn adjustment screw towards the L to
Move drawer front left. Turn adjustment screw towards the
R to move drawer front right.
Tilt adjustment - To increase the drawer front gap, turn the
adjustment screw clockwise, to decrease turn adjustment
screw counterclockwise.
Note: Height, side and tilt adjustments must be achieved with a T20 Torx screwdriver