To Next PageTo Next Page
Need help?Do you have a question about the BMETERS Hydrosplit-M3 and is the answer not in the manual?
General| Brand | BMETERS |
|---|---|
| Model | Hydrosplit-M3 |
| Category | Measuring Instruments |
| Language | English |
Installation must be carried out by qualified personnel only. Manufacturer does not assume responsibility for improper installation.
Calculator contains potentially dangerous batteries; handle carefully and do not dump in the environment.
Lists the items included in the package: calculator, mounting bracket, screws, manual, seal.
Provides important notes regarding installation, regulations, warranty, and flow meter configuration.
Instructions on how to open the calculation unit and mount it using brackets or DIN rails.
Details the two types of wall mounting allowed: direct or via DIN Rail.
Refers to a separate manual for temperature sensor installation procedures.
Refers to a separate manual for flow meter installation procedures.
Guides on connecting flow/volume meters, sensors, and M-Bus to the terminal board.
Specific instructions for connecting inlet and return temperature sensors to terminals 5-8.
Describes connecting volume meters for hot/cold water to C1 IN (51-53) and C2 IN (54-56) inputs.
Details connecting the calculator to an M-Bus network using an M-Bus network cable.
Covers pulse outputs and M-Bus interface for remote reading.
Describes the calculator's use for thermal energy and volume measurement.
Step-by-step guide to enter the programming menu using T1 and T2 buttons.
Setting the pulse value 'k' for the heating system flowmeter.
Enabling/disabling anti-tampering contact for the heating system flowmeter.
Enabling/disabling anti-tampering contact for C1 and C2 water meters.
Setting pulse value 'k' for C2 water meter and heating pulse output.
Setting the pulse value 'k' for the cooling pulse output.
Setting secondary and primary addresses for the Wired M-Bus (heating data).
Setting secondary and primary addresses for the Wired M-Bus (cooling data).
Setting the primary address for the Wired M-Bus (cooling data).
Option to save configured parameters or return to the previous sublevel.
Describes displays related to cumulative energy and volume values.
Covers displays for actual power, flow rate, and temperature readings.
Details various settings and parameters displayed but not configurable in this level.
How the calculation unit signals anomalies and displays error icons.
