g) Adjust the Sensor and Key so that the point where the sensor comes ON is where
the Indexer stops at its correct Home Position.
h) Mark the Home position Station on the Indexing Wheel (if not already marked)
i) Change the Pneumatic Cylinder connections back to normal to bring it down and
Remove the Can by manually turning the indexing wheel.
j) Now rotate the Indexing wheel and introduce a Can in the Home Position station on
the Indexing Wheel (as marked above). Position the indexer such that the Can is
before the seaming station.
k) Power ON the machine and press the Home Position Icon. The Indexer should
slowly move forward and stop at its Home Position with the Can directly below the
seam station.
l) Raise the Can up using the Controller and check for alignment. If OK, the machine
is ready to operate.
If not, OK repeat the process above and fine tune till the proper setting is achieved.
This may take a few times to get the absolute right position.
To Next Page
Loading...