Operating requirements
The windows can be operated under the
following conditions.
▷ Standby state is switched on.
▷ Drive-ready state is switched on.
▷ For a short while after rest state has been
established.
The vehicle key or a digital key must be inside
of the vehicle.
Opening windows
▷ Press the switch as far as the resist-
ance point.
The window opens for as long as
the switch is held.
▷ Press the switch past the resistance
point.
The window is opened automati-
cally. Pressing the switch again stops the
movement.
Close windows
▷
Pull the switch as far as the resist-
ance point.
The window closes for as long as
the switch is held.
▷ Pull the switch past the resistance
point.
The window closes automatically.
Pulling the switch again stops the move-
ment.
Anti-trap mechanism
Principle
The anti-trap mechanism prevents objects or
parts of the body from becoming trapped be-
tween the door frame and window while a win-
dow is being closed.
General
If resistance or an obstruction is detected while
a window is being closed, the closing process
is interrupted.
Safety information
WARNING
Accessories on the windows, for example
aerials, can impair the anti-trap mechanism.
There is a danger of injury. Do not attach
any accessories within the movement range
of the windows.
Closing with no anti-trap mechanism
If an external hazard or ice prevents normal
closure, proceed as follows:
1.
Pull the switch past the resistance
point and hold it in this position.
The window is closed but with restricted
anti-trap mechanism. If the closing force
exceeds a certain level, the closing opera-
tion is interrupted.
2. Pull the switch past the resistance
point again within approximately 4 seconds
and hold it in this position.
The window is closed with no anti-trap
mechanism.
Seite 93
Opening and closing
CONTROLS
93
Online Edition for Part no. 01405A5E758 - VI/22
To Next Page
Loading...
