exceeds a certain level, the closing opera-
tion is interrupted.
3. Slide the switch forwards once again be-
yond the resistance point and hold until
the glass sunroof closes with no anti-trap
mechanism. Ensure that the closing range
is clear.
Closing with no anti-trap mechanism
from a raised position
If an external hazard or ice prevents normal
closure, proceed as follows:
1.
Close all doors.
2. Slide the switch forwards beyond the re-
sistance point and hold it in this position.
Initialising after an open circuit
General
If a open circuit occurs while the glass sunroof
is opening or closing, it may only have restric-
ted functionality afterwards. In this case, initial-
ising the system can help.
The system can be initialised if the following
conditions are met:
▷
The vehicle is parked on level ground.
▷ The vehicle does not move until initialisa-
tion is complete.
▷ Drive-ready state is activated.
▷ The outside temperature is above
5 ℃/41 ℉.
During initialisation, the glass sunroof closes
with no anti-trap mechanism.
Ensure that the closing range is clear.
Initialising the system
Press the switch up and hold
until initialisation is complete:
Initialisation begins within 15 seconds.
▷ If the glass sunroof is closed, it opens, then
closes again.
▷ If the glass sunroof is open, it first closes,
then opens and closes again.
Initialisation is complete once the glass sun-
roof and sun visor have opened, then closed
again.
Seite 97
Opening and closing
CONTROLS
97
Online Edition for Part no. 01405A5E758 - VI/22
To Next Page
Loading...
