TeleService, BMW Assist
162
3. Select "Communication settings" and
press the controller.
4. Select "BMW Service settings" and press
the controller.
5. Select "Service Status" and press the con-
troller.
6. Select "Enable services" and press the con-
troller.
TeleService and, if applicable, BMW Assist
are enabled; data exchange with the service
center starts.
Enabling takes a few minutes. The status is dis-
played on the Control Display. If you open
another menu, the enable process continues to
run in the background.
Services offered
The following special features apply for the ser-
vices of TeleService and BMW Assist:
> The services offered are country-specific.
> Voice contact is established or data are
transferred, depending on the equipment
and the country. In some countries, it is
possible to do both.
> The data transferred can be the vehicle
data, your current position or the data of the
CBS Condition Based Service.
Automatic service notification*
The data on the service status of your vehicle or
on legally mandated inspections is transmitted
automatically directly to your BMW center prior
to the due date. You can check when the BMW
center was notified.
iDrive, for explanation of principle, refer to
page 16.
1. Open the start menu.
2. Press the controller to open the menu.
3. Select "Service" and press the controller.
4. Select "Service requirements" and press
the controller.
Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG
To Next Page
Loading...
Need help?
General
