Operating requirements
▷ At least one driver profile has been created.
▷ A driver profile or the guest profile is active.
▷ A ConnectedDrive account is assigned to at
least one driver profile.
Calling up the menu for parking
service mode
Via the switch-off screen
The switch-off screen is displayed after switch‐
ing off the drive-ready state. Select the entry for
parking service mode in the switch-off screen.
Via the display bar at the top of the
Control Display
1.
Tilt the Controller up
2. "Valet parking mode"
Via the vehicle settings
Via iDrive:
1.
"CAR"
2. "Settings"
3. "General settings"
4. "Valet parking mode"
Activating parking service mode
General
Before activating parking service mode, a PIN
must be defined so that parking service mode
can be deactivated later on.
The procedure for entering a PIN varies depend‐
ing on the active driver profile.
Driver profile with PIN
A PIN has been defined for the active driver pro‐
file.
It is not necessary to enter another PIN.
1.
Select the desired setting:
"Lock tailgate as well"
The boot lid is locked and disconnected from
the central locking system.
2. "Activate now"
Driver profile without PIN
A PIN must be assigned to the driver profile.
1. "PIN"
2. PIN required.
3. Select the desired setting:
▷ "Lock tailgate as well"
The boot lid is locked and disconnected
from the central locking system.
▷ "Activate linkage"
This PIN is defined for the active driver
profile.
4. "Activate now"
Guest profile
The active driver profile is the guest profile.
A PIN must be entered.
1.
"PIN"
2. PIN required.
3. Select the desired setting:
"Lock tailgate as well"
The boot lid is locked and disconnected from
the central locking system.
4. "Activate now"
This PIN can be used once to deactivate
parking service mode when the guest profile
is active.
Deactivating parking service
mode
General
The lock screen for parking service mode is dis‐
played on the Control Display.
Seite 106
CONTROLS
Opening and closing
106
Online Edition for Part no. xxx - VI/19
To Next Page
