▷ Inadvertent shifting to selector lever posi‐
tion R.
▷ Inadvertent change from selector lever posi‐
tion P to another selector lever position.
1. Fasten the driver's seat belt.
2. Press and hold the button to cancel the se‐
lector lever lock.
3. Briefly press the selector lever in the desired
direction, possibly overcoming a resistance
point. The selector lever returns to the middle
position when released.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle
General
In some situations, the vehicle may need to be
rolled a short distance without power, for exam‐
ple in a car wash, or may need to be pushed.
Engaging selector lever position N
1. Switch on drive-ready state while pressing
the brake.
2. If necessary, release the parking brake.
3. If necessary, switch off Automatic Hold, see
page 147.
4. Depress the brake pedal.
5. Touch the selector lever lock and engage se‐
lector lever position N.
6. Switch off drive-ready state.
Standby state then remains switched on and
a Check Control message is shown.
The vehicle can now roll.
NOTE
Selector lever position P is automatically en‐
gaged when standby state is switched off.
There is a risk of material damage. Do not
switch off standby state in car washes.
Selector lever position P is automatically en‐
gaged after approximately 35 minutes.
If there is a fault, it may not be possible to
change the selector lever position.
Unlock the transmission lockout electronically if
necessary, see page 157.
Kick-down
Kick-down enables you to achieve maximum
performance.
Press the accelerator pedal down beyond the
regular full-throttle position; some resistance will
be felt.
Seite 155
Driving
CONTROLS
155
Online Edition for Part no. xxx - VI/19
To Next Page
Loading...
