tion and the area around the vehicle and inter‐
vene actively where appropriate.
Overview
Depending on the equipment:
button in the vehicle
Park Assistant button
Camera
The camera lens is located in the handle strip of
the boot lid.
Dirt can impair the quality of the image. Clean the
camera lens if required.
Switching on/off
Automatic activation
The system is automatically switched on if selec‐
tor lever position R is engaged while the engine
is running.
Automatic deactivation when
moving forwards
The system switches off once a certain distance
or speed is exceeded.
Switch the system back on if necessary.
Depending on the equipment:
switching on/off manually
Press the Park Assistant button.
▷ On: the LED is illuminated.
▷ Off: the LED is extinguished.
The parking assistance functions are shown on
the Control Display.
Switching the view via iDrive
If the rear-view camera view is not displayed,
change the view via iDrive:
1.
If necessary, tilt the Controller to the side.
2. "Rear view camera"
The image from the rear-view camera is shown.
Operating requirements
▷ The rear-view camera is switched on.
▷ The boot lid is completely closed.
▷ Keep the detection area of the camera clear.
Projecting loads or carrier systems and trail‐
ers that are not connected to a trailer socket
can restrict the detection area of the camera.
Assistance functions
General
A number of assistance functions can be active
simultaneously.
The assistance functions can be activated man‐
ually.
1.
If necessary, tilt the Controller to the right.
2. With the corresponding equipment:
"Camera picture"
Seite 260
CONTROLS
Driver Assistance Systems
260
Online Edition for Part no. xxx - VI/19
To Next Page
Loading...
