BMW 318D - Page 291

Button Function
Seat heating, see page 127.
Switch off.
Switching on/off
Via iDrive
1. "CAR"
2. "Settings"
3. "Climate comfort"
4. "Heating/ventilation"
5. "Second row of seats"
6. "Activate heating/cooling"
The rear automatic air conditioning is not opera‐
tional if the automatic air conditioning is switched
off or the following function is active: defrost the
windows and remove condensation.
Using the button: switch on
Press any button, with the following exceptions:
▷ Switch off.
▷ Seat heating.
Using the button: switch off
Press the button.
Temperature
Principle
The automatic air conditioning adjusts to the set
temperature as quickly as possible, using maxi‐
mum cooling or heating power if necessary. The
temperature is then maintained.
Adjusting
Press the left or right side of the button
to set the desired temperature.
Via iDrive:
1. "CAR"
2. "Settings"
3. "Climate comfort"
4. "Heating/ventilation"
5. "Second row of seats"
6. "Temperature"
7. Set the desired temperature.
Selected temperature is shown on the climate
display.
Avoid switching between different temperature
settings in rapid succession. The automatic air
conditioning may not have sufficient time to es‐
tablish the temperature selected.
Maximum cooling effect
Principle
When drive-ready state is switched on, the sys‐
tem is set to lowest temperature, optimum air
flow and recirculated-air mode.
General
The function is available at an outside tempera‐
ture above approximately 0 ℃/32 ℉ and when
drive-ready state is switched on.
Switching on/off
Press the button.
The LED is illuminated when the sys‐
tem is switched on.
The air flows from the side nozzles for the upper
body area. Therefore open the side nozzles.
AUTO programme
Principle
The air flow, air distribution and temperature are
automatically regulated.
Seite 291
Air conditioning
CONTROLS
291
Online Edition for Part no. xxx - VI/19