The tank in the vehicle is filled when the level
in the bottle does not change any more. It is
not possible to overfill.
6. Pull back bottle and unscrew.
7. Put fuel tank cap back on and turn clockwise.
8. Press on the fuel filler flap until it engages.
Filling with an incorrect fluid
General
A Check Control message is displayed if the tank
has been filled with the wrong fluid.
If the wrong type of liquid has been added, con‐
tact a Service Partner of the manufacturer or an‐
other qualified Service Partner or a specialist
workshop.
Safety note
WARNING
After filling with an incorrect liquid, the system
may heat up and catch fire. There is a risk of
fire and danger of injury. Only fill with liquids
that are intended for the tank. Do not start the
engine after filling with an incorrect liquid.
After filling reduction agent
Reserve level indicator
After topping up, the reserve level
indicator continues to be shown
with remaining range.
Drive-ready state can be estab‐
lished.
After a journey of several minutes, the reserve
level indicator goes out.
AdBlue on the minimum level
After filling up, the display contin‐
ues to be shown.
Drive-ready state can only be es‐
tablished when the display is no
longer illuminated.
1.
Press the start/stop button three times.
Display is no longer illuminated after approxi‐
mately 1 minute.
2. Press the start/stop button and switch on the
drive-ready state.
Disposing of bottles
Dispose of bottles for AdBlue at a Serv‐
ice Partner of the manufacturer or an‐
other qualified Service Partner or a spe‐
cialist workshop or hand them into an authorised
collecting point.
Only dispose of bottles with normal waste if the
local regulations permit this.
Seite 369
Operating fluids
MOBILITY
369
Online Edition for Part no. xxx - VI/19
To Next Page
Loading...
