166n
Lights and bulbs Remote control for auxiliary heater
*
Licence plate lights
5 Watt bulb
1. Insert screwdriver into slot and press
to the left (arrow); this will release the
light
2. Take out the light and change the
bulb.
394de772
Changing the batteries
Renew the batteries if the indicator light
no longer flashes when the auxiliary
heater is switched on.
1. Pull open cover 1 for battery
compartment
2. Insert two batteries 2 of the same
type (LR 1). Battery type and installed
position are marked on the base of
the battery compartment
3. Press the cover back into position.
Dispose of old batteries only at an
authorised collecting point or
return them to BMW Service.
<
390de156
New transmitter
If you begin to use a new transmitter
(either a replacement or an additional
transmitter), it must first be initialised.
Either one or two transmitters can be
used.
Observe the times stated below
accurately, otherwise initialising
will fail and have to be repeated.
<
1. Remove the fuse for the auxiliary
heater (in luggage compartment or
load area on right, see page 172) and
insert it again after 10 seconds
2. Within 3 seconds of having inserted
the fuse again, press button 3
3. Next, press button 4 within 5
seconds
4. After a further 3 seconds, the system
is operational.
ba.book Page 166 Tuesday, December 17, 2002 4:26 PM
To Next Page
Loading...
