81n
OverviewControlsMaintenanceMinor repairsDataKeywords
Graphic display
The following instructions and status
messages are depicted as symbols and
sound a gong from ignition setting 2.
They remain on display until the faults
have been remedied:
1 Check low- and high-beam head-
lights and parking lights
2 Top up washer fluid goes out after
approx. 1 minute
3 Door open
4 Luggage compartment lid/tailgate
open
5 Check rear light or brake light. A
defective third (centre) brake light is
indicated by the upper symbol
At the end of a journey, when the driver's
door is opened, the LIGHTS ON signal
may be heard without any visual display.
390de121
Alphanumeric display
*
Clear-text instructions and reminders
are shown in ignition key position 2 and
beyond. A gong signal is always heard
at the same time.
1 Symbol that a warning is present
2 Display
3 CHECK key
The system malfunction displays are
divided into two priority categories:
390de111
Priority 1
These displays appear immediately,
accompanied by a gong signal and by
flashing fault display symbols 1. If
several faults occur at the same time,
they are displayed in succession. The
displays remain in force until the faults
have been rectified, and cannot be
erased with CHECK button 3:
>
"RELEASE PARKINGBRAKE"
>
"COOLANT TEMPERATURE"
The temperature is too high. Stop the
car immediately and switch off the
engine; see page 152
>
"STOP! ENGINE OILPRESS"
Engine oil pressure has dropped too
low. Stop the car immediately and
switch off the engine; see pages 17,
150
Check Control
ba.book Page 81 Tuesday, December 17, 2002 4:26 PM
To Next Page
Loading...
