BMW 630CS - 1 st BMW Inspection after 1000 km (app. 600 miles)

62 Service
1st BMW lnspection
after 1000 km (app. 600 miles)
1. Change engine oil (including oil filter)
while at normal' operating tempera-
ture. Fìenew oil filter element.
2. Change oil while at normal operating
3.tcehma:.à[eatouiìeiin,thhee,TnaaTudarl,geeawr£::.at
4.E:[#haàfoÉP:rcaf:ncgkt:,gxìà[:t:ra:{ersfor
leaks.
5. Check steering box, steering arm
bearing (FÌHD cars) or power steering
for leaks; check oil level and add
more oil if necessary.
6. Check cooling system hoses for leaks
Fenv:,tiagnhdteann#rseez:'à:sricce#ak,i:on?'taonpt
up if required.
7.Check unions and pipes in brake
system for leaks, damage or incorrect
location.
8. Clean strainer in carburetor feed line
and take up any slack at fuel pump
bolts.
9. Take up any slack at the carburetor
nuts and bolts.
10.Fuel injection engines: Grease
throttle butterfly lever pivot points
and gate. Take up any slack at
retaining clips and bolts on injector
holders. Check pipes for correct
location and absence of leaks.
11. Check free movement of automatic
i ntake air preheat flap valve.
12. Check V-belt tension and adjust if
necessary..
13. Take up any slack at nuts and bolts
(note correct tightening torques, see
Specifications) on: Ieft and right
rubber/métal engine mountings,
a::àne:tjjTtjankgec=:cs:::r,gj,;*bàtnodr
exhaust manifold, oil sump, cylinder
head bolts.
14. Check valve clearances and adjust if
necessary.
15. Take up any slack at nuts and bolts
(note correct tightening torques, see
Specifications) on: front axle,
steeri ng, track rods, gearbox, exhaust
system, propeller shaft, halfshafts,
rear, aLxle, brakes, wheels.
16. Take up slack at nuts and bolts on
engine and luggage compartment
hinges and catches, door locks
and stri kers.
17. Check steering for freedom from play
and adjust if necessary.
18.Check foot brake and bleed if
necessary. Check handbrake and
adjust if necessary. Check brake fluid
level in reservoir and add more fluid
if necessary.
19. Check front wheel bearing play and
adjust if necessary.
20. Check front wheel toe-in and adjust if
necessary.
21. Check tire pressures and correct if
22.àehgcsksigàd,ightandauxi,iarydriving
light beam settings and correct if
necessary.
23.9ehaer:k'igtèirnsgn;.quipiT:::e`parpiian,g:
interior, glove box, engine and
l uggage compartment lights),
warning equipment (hazard warning
flashers, turn indicators, brake lights,
g:£à,lià;ta,:liigsh,t.uftgnhte:,ndr:::c;iopg
tion lighting, telltale and warning
lamps, windshie[d wipers and
washers (blades, washer unit for
windshield and for headlights if fitted,
reservoir fluid level and antifreeze
concentration, jet positioning for
windshield and for headlights if fitted)
and heater blower.
24.Specified engine test with BMW
Program Tester. Check engine idle
and exhaust emission settings and
correct if necessary.
25. Final inspection with safety check
(brakes, bedding in handbrake lin-
ings, steering, clutch or automatic
transmission).
Note: Balance wheels (to be invoiced
additionally) if requested.