64 Service
throttle butterfly lever pivot points
and gate.
14.Tighten nuts at exhaust manifold
(note correct tightening torque).
Check carburetor and fuel pump
mountings.
15. Check valve clearances and adjust if
necessary.
16. F`enew intake air cleaner elements. If
car is operated in dusty conditions,
renew at more frequent intervals.
17. Check steering for freedom from play
and adjust if necessary. Check con-
dition of track rod and front suspen-
sion joint§ and pivots.
18. Halfshafts and propeller shaft: check
condition of joints and rubber coup-
'ing.
19. Take up any slack at nuts and bolts
(note correct tightening torques, see
SPECIFICATIONS) on: steering box
mounting, brake caliber mountings,
halfshafts.
20. Check condition, positioning, attach-
ment and freedom f rom leakage of
exhaust system.
21. Disc brakes: check overall pad thick-
ness (pads removed) and condjtìon of
disc surfaces; renew pads if nec-
essary.
22. Front wheel bearings: check play and
adjust if necessary.
23. Check tire pressures and correct if
necessary. Check tjre condition: if
wear is uneven, option of wheel align-
ment check and adjustment (to be
invoicedadditionally).
24. Check brake system unions and pipes
for leakage, damage or incorrect
positioning. Check free movement of
handbrake cables. Adjust brake.
25. Take up slack at hinges and catches
on doors, engine and luggage com-
partment lids, and oil or grease as
specified. Check adjustment and
correctoperation.
26. Check lighting equipment (head-
lights*, auxiliary driving lights*, park-
ing, rear, reversing, Iicense plate,
interìor, glove box, engine and
!:ggagàu:3#g:tftm,etEtm"gi:sd)ic:,:r.T:
hazamd waming flashers, brake lights,
horn, headlight flasher, rear fog
ià:m::!,ig!i,:#eòr;sni:rl#à#ànat;#t:a:à3di!ps!
washer unit [windshield and head-
lights if so equipped], fluid tank level
and antifreeze concentration and jet
positions [windshield and headlights
if so equipped] ), and heater blower.
27. Check condition and correct oper-
ation of seat belts.
28.Test engine with BMW Program
Tester as specified. Check engine idle
settings and exhaust emissions and
adjust if necessary.
29. Final inspection of items affecting
road safety (brakes, bedding in hand-
brake linings, steering, clutch or
automatic transmission, springs and
shock absorbers [visual inspection
only], mirrors).
Note: lf requested, balance wheels as
specified after interchanging (to be
i nvoiced additionally).
Every 30000 km (20000 miles), to be
invoiced additionally:
Change oil while at normal operating
temperature in the manual gearbox or
automatic transmission and final drive.
Check .clutch driving plate for wear.
S;:{e8:ahmeai#ì:tgsa|fdnaeucx*jsaavy.d8¥in=
•strainer in carburetor feed line. Clean
'inlet filter in fuel tank suctìon unit or in
immersed level sensor. Renew main fuel
filter.
Fnvveo%e3oaododìtì5Ta,t;:oooo m,,es,, to be
Power steering: check correct operation,
renew filter.
Impor[ant: renew coolant every 2 years.
Apply fresh underseal and renew body
cavity treatment not later than 14 months
after initial registration of the car, then
after 36 months.
* Check correct operation only; adjust-
ment not included.
To Next Page
Loading...
