70 Lubrication ofdistributor, brake fluid
After the engine has been stopped, fluid
Lebv:temtà:|:svee,b#,pk?r::;,:c:Théo:2.j:!
in position and tighten the wingnut. Make
sure that the lid seats correctly and that
there are no leaks in the steering sy§tem.
All other work - filter renewal and
operational checking -should always be
carried out by an authorized BMW
service station.
Lubi.icate the distributor (BMW 630 CS)
during a BMW lnspection every 15000 km
(10000 miles).
Apply a narrow wedge of Bosch Ft 1 v 4
grease to the fiber sliding section of the
breaker arm on the side facing the arm
pivot.
The distributor on the breakerless tran-
sistorized coil ignition system used on
the BMW 633 Csi needs no routine
maintenance.
The transparent reservoir for brake fluid
(and for the hydraulic clutch withdrawal
Faenc:::̧.mn),ise,ienf:da:dtt:aeb|g:n,:effi
level to be checked without removing the
Cap.
lf the fluid level should fall below a cer-
tain level, an electric warning device ir
the reservoir will cause the red "Brake.
warnig lamp in the instrument cluster to
light up.
Brake fluid is hygroscopic, that is to say
it absorbs moisture from the ai r gradually
over a period. ln order to ensure that the
:àLeàrn:nndaff:g,i:i;nt:yeborfakyeo:,ru,dbr:L=
be renewed once a year by an autho-
rized BMW service station.
Add tluid up to the upper "MAX" mark.
Your BMW Seivice Station knows the
factory-approved g rades of brake fl uid.
To Next Page
Loading...
