149n
Index Data Technology Repairs Car care Controls Overview
Lamps and bulbs
Front fog lamps*
H1, 55-watt bulb
1 Unclip the plastic cover (on the inside
of the fog lamp) with a screwdriver.
2 Loosen two screws, tilt the fog lamp
outward and remove it.
3 Release the plastic cap on the back
of the fog lamp and remove it.
4 Remove the plug.
5 Detach the wire clamp.
6 Replace the bulb.
7 Install in the reverse order.
367de377
Tail lamp assembly – Z3 roadster
Tail lamp, side marker lamp:
5-watt bulbs
Remaining bulbs: 21 watts
1 Turn signal yellow
2 Brake lamp red
3 Backup lamp white
4 Tail lamp, reflector red
5 Side marker lamp red
367de370
Z3 roadster
1 Open the quick-release fastener
(arrow) and remove the cover.
2 Turn the corresponding bulb holder
to the left and remove it.
3 Press the defective bulb gently and
turn it to the left. Remove the bulb
and replace it.
4 Insert the bulb holder and turn to the
right as far as possible.
5 Secure the cover.
To Next Page
