BMW M2 - Page 164

Switching on/off and interrupting
cruise control
Switching on
Press the button on the steering wheel.
The marking in the speedometer is set to the
current speed.
Cruise control can be used.
DSC Dynamic Stability Control is switched on, if
necessary.
Switching off
Press the button on the steering wheel.
▷ If active: press twice.
▷ If interrupted: press once.
The displays go out. The stored desired speed is
deleted.
Interrupting manually
When active, press the button on the
steering wheel.
Interrupting automatically
The system is automatically interrupted in the
following situations:
▷ When the driver applies the brakes.
▷ If the clutch pedal is depressed for a few sec‐
onds or released while a gear is not engaged.
▷ If the gear engaged is too high for the current
speed.
▷ When M Dynamic Mode MDM is activated or
DSC Dynamic Stability Control is deactivated.
▷ If DSC Dynamic Stability Control intervenes.
Setting the speed
Maintaining/storing the speed
Press the rocker switch up or down once while
the system is interrupted.
When the system is switched on, the current
speed is maintained and stored as the desired
speed.
The stored speed is displayed in the speedome‐
ter and in the instrument cluster, refer to
page 165.
DSC Dynamic Stability Control is switched on, if
necessary.
The speed can also be stored by pressing a but‐
ton.
Press the button.
Changing the speed
Press the rocker switch up or down repeatedly
until the desired speed is set.
If active, the displayed speed is stored and the
vehicle reaches the stored speed when the road
is clear.
Seite 164
CONTROLS
Driving comfort
164
Online Edition for Part no. 01402720665 - II/19