Adjusting the height
▷ To lower: press the button, arrow 1, and push
the head restraint down.
▷ To raise: push the head restraint up.
After setting the height, make sure that the head
restraint engages correctly.
Removing
The head restraints cannot be removed.
Cushions for head restraints in
the rear: basic seat
Only use the pillow when the vehicle is switched
off.
1.
Bring the head restraint to a sufficiently high
position.
2. Attach the pillow and place the pillow band
around the back of the head restraint, ar‐
row 1.
3. Close pushbuttons, arrow 2.
Cushions for head restraints in
the rear in 6-seater
Only use the pillow when the vehicle is switched
off.
1. Pull the upper tab through the loop on the
top of the head restraint.
2. Close both pushbuttons.
3. Move the head restraint into the topmost po‐
sition.
4. Close the pushbutton on the lower tab and
the pushbutton on the bottom of the head re‐
straint.
Seite 131
Seats, mirrors and steering wheel
CONTROLS
131
Online Edition for Part no. 01405A385B6 - VI/21
To Next Page
Loading...
