BMW XM - Page 113

Opening/closing the cover
To open:
1. Grasp the lower edge of the cover and fold
it upwards.
2. Slide the lug on the outside of each back-
rest into the gap.
To close:
1.
Guide the cover down.
2. Slide the side section lug of the cover into
the lower gap on the outside of the respec-
tive backrest.
Before attaching child restraint
systems
Pull the seat belt away from the area of the
child seat mountings.
Installing child restraint systems
1.
Mount child restraint system, see manufac-
turer's information.
2. Make sure that the child restraint system
mount is correctly engaged in the lower an-
chor on both sides.
Child restraint systems with
tether strap
General information
When attaching child restraint systems to the
upper attachment points, observe the specifi-
cations and the operating and safety informa-
tion of the child restraint system manufacturer.
Safety information
Warning
If the upper retaining strap is incorrectly used
for the child restraint system, the protective
effect is reduced. There is a risk of injury. En-
sure that the upper retaining strap is guided
to the upper attachment point without twist-
ing and not over sharp edges.
Warning
If the rear seat backrest is not locked, the
protective effect of the child restraint system
is limited or nonexistant. In certain situations,
for instance braking maneuvers or in case of
an accident, the rear seat backrest can fold
forward. There is a risk of injury or danger to
life. Make sure that the rear seat backrests
are locked.
Warning
The mounts for the lower mountings and at-
tachment points of the child restraint system
are intended for attaching child restraint sys-
tems only. If other objects are attached, the
mounts or attachment points can be dam-
aged. There is a risk of injury or risk of dam-
age to property. Only attach child restraint
systems at the corresponding mounts for the
lower mountings or attachment points.
Seite 113
Transporting children safely
CONTROLS
113
Online Edition for Part no. 01405A8A608 - VI/23