EasyManua.ls Logo

BMW XM - Page 352

BMW XM
416 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
All wheels green
The system is active and bases warnings
on the target pressures.
For tires with special approval: the system
is active and bases warnings on the tire
inflation pressures stored during the last re-
set.
One to four yellow wheels
A flat tire or major tire pressure loss has occur-
red in the indicated tires.
Gray wheels
It may not be possible to identify tire pressure
losses.
Possible causes:
Malfunction.
During tire inflation pressure measurement,
after confirmation of the tire settings.
For tires with special approval: a reset is
performed for the system.
For tires with special approval:
performing a reset
1.
Apps menu
2. "Vehicle"
3. "Vehicle status"
4. "Tire Pressure Monitor"
5. Make sure that the tire settings are correct.
Tire settings, refer to page 351.
6. Turn on drive-ready state and do not drive
off.
7. Reset tire pressure: "Perform reset".
8. Drive off.
The wheels are displayed in gray and the fol-
lowing is displayed: "Resetting tire pressure…".
After a travel time of several minutes, the set
tire inflation pressures are accepted as the
predefined tire inflation pressures. The reset is
completed automatically while driving.
After a successfully completed reset, the
wheels on the control display are shown in
green and the following is displayed: "Reset
successful."
You may interrupt this trip at any time. When
you continue driving the reset resumes auto-
matically.
Messages: for tires without special
approval
General information
When a flat tire is indicated, the Dynamic Sta-
bility Control may be turned on.
Safety information
Warning
A damaged regular tire with low or no tire
inflation pressure impacts handling such as
steering and braking response. There is a risk
of accident. Do not continue driving. Repair
the flat tire or replace the wheel.
With recommended tire pressure test
Message
An icon with service information is shown on
the control display and, if necessary, in the My
BMW App.
Icon
Possible cause
Leak detected on the tire.
Measure
Check the tire pressure and correct as needed.
Seite 352
MOBILITY
Wheels and tires
352
Online Edition for Part no. 01405A8A608 - VI/23