BMW Z4 - Page 167

End of warning
The warning is canceled in the following situa‐
tions:
▷ Automatically after approx. 3 seconds.
▷ When returning to your own lane.
▷ When braking hard.
▷ When using the turn signal.
▷ If DSC Dynamic Stability Control intervenes.
System limits
Safety information
Warning
The system is designed to operate in certain
conditions and circumstances. Due to condi‐
tions or other factors, the system may not re‐
spond. There may be a risk of accident or risk
of damage to property. Actively intervene as
warranted. Refer to the information in this Own‐
er’s Manual regarding the scope of the sys‐
tem’s operation and limitations.
Functional limitations
The system may not be fully functional in the fol‐
lowing situations:
▷ In heavy fog, wet conditions, or snowfall.
▷ In the event of missing, worn, poorly visible,
merging, diverging, or multiple lane markings
such as in construction areas.
▷ When lane markings are covered in snow, ice,
dirt or water.
▷ In tight curves or on narrow lanes.
▷ When lane markings are covered by objects.
▷ When driving very close to the vehicle in front
of you.
▷ If there are constant blinding effects because
of oncoming light, for instance from the sun
low in the sky.
▷ If the field of view of the camera or the wind‐
shield is dirty or covered in the area of the in‐
terior mirror.
▷ If the camera has overheated and been tem‐
porarily switched off due to excessively high
temperatures.
▷ Up to 10 seconds after the start of the engine
via the Start/Stop button.
▷ During calibration of the camera immediately
after vehicle delivery.
A Check Control message may be displayed
when the system is not fully functional.
Blind spot collision warning
Concept
Blind spot collision warning detects vehicles in
the blind spot or vehicles approaching from be‐
hind in the adjacent lane. A warning is issued in
various gradations in these situations.
General information
Two radar sensors in the rear bumper monitor
the area behind and next to the vehicle when
traveling faster than a minimum speed.
The minimum speed is shown in the menu for
the intelligent Safety systems.
The system indicates whether there are vehicles
in the blind spot, arrow 1, or approaching from
behind in the adjacent lane, arrow 2.
The light in the exterior mirror lights up dimmed.
Seite 167
Safety
CONTROLS
167
Online Edition for Part no. 01402779113 - II/19