27
© 2005 Directed Electronics, Inc.
step 7
Factory Alarm Disarm
Since some newer vehicles come equipped with a factory alarm
system, it maybe necessary for the factory alarm to be disarmed
when remote starting the vehicle. Most vehicles have a (-) disarm
trigger.
Locate the factory alarm disarm wire using the web site vehicle
information. Once the suspect wires are located, place the red
lead of the LED tester to a (+)12 volt constant source and secure
it. Probe the suspect wire with the LED tester. While probing
the wire, place the key in the drivers door cylinder. Turn it to the
unlock position and hold it when testing for the disarm wire.
The LED tester should illuminate and will extinguish when the
key is released.
When the correct wire has been found, strip a small portion of
insulation off this wire and solder the small LIGHT
GREEN/BLACK (H1/7) wire to this wire. Wrap the connection
with electrical tape.
note: Some vehicles use a + trigger system. Use the
www.boasecurity.com website to determine if your vehi-
cle has a + trigger system. If this vehicle has this system
call
11--880000--887733--11331144
for live technical assistance as spe-
cial wiring and an additional relay is required.
➜
note! For the programming of the tachometer, refer to
the
Control Module Programming
discussion.
To Next Page
Loading...