Bobcat 600 - User Manual

Guidelines for tire pressure, rotation, and filling for optimal loader performance.

Information on using calcium chloride in tires for stability and traction.

Procedure and intervals for lubricating loader fittings with lithium base grease.

Guidelines for changing hydraulic oil based on hours and condition.

Procedure for checking and adding hydraulic oil on a level surface.

Step-by-step process to remove accumulated water from the hydraulic reservoir.

Inspection of Bob-Tach frame and weld areas for structural integrity.

Step-by-step guide for replacing the hydraulic fluid filter element and housing seal.

Procedures for cleaning and inspecting the engine air cleaner system for leaks.

Procedure for cleaning and refilling the oil cup for the oil type air cleaner.

Instructions for inspecting the heavy duty air cleaner indicator and vanes.

Oil capacity specifications for Wisconsin, Deutz, and Petter engines.

Recommended SAE viscosity numbers for engine oils based on temperature.

Steps for removing and installing the engine oil filter on Wisconsin engines.

Procedure for changing the engine oil filter on Deutz Diesel engines.

Steps for removing and replacing the oil filter element and cover on Petter engines.

Inspection of fittings and hoses for leaks on the Wisconsin crankcase air vent.

Procedure for removing, cleaning, and installing the Deutz crankcase air vent element.

Specifications for gasoline and diesel fuels used in different engine types.

Maintenance and replacement of fuel filters for LP Gas, Deutz, and Petter engines.

Adjusting the excess fuel lever for proper operation of Deutz engines.

Checking fuel pump pressure and adjusting float level for Wisconsin engines.

Procedure for adjusting fuel supply on Petter engines for optimal power and minimum smoke.

Maintaining proper air circulation and cleaning cooling fins for engines.

Operation and maintenance procedures for the water scrubber muffler.

Steps to check and adjust ignition timing on Wisconsin engines using a timing light.

Adjusting the contact gap on the distributor for Wisconsin engines.

Checking spark plug gap, cleaning, and replacement guidelines.

Procedures for testing the regulator and rectifier modules using an ohmmeter.

Testing stator leads for shorts and checking voltage output with a voltmeter.

Testing alternator output and charging rate with a voltmeter and ammeter.

Using a test light to check for open circuits in regulator connections.

Testing regulator output voltage using a voltmeter.

Checking the regulator field terminal for correct voltage settings.